Titanium c*rd using USB Infinity Phoenix:
You will need to have both USB and Serial Port Cable connected.
Start the Infinity USB program Program, select Phoenix mode 3.68 (some require Phoenix mode 3.57
try if 3.68 doesn't work).
If it is a new c*rd you will have to do 2 uopgrades of the OS, so download Titanium Progger 1.8.1
and Titanium Progger 1.9.0
Start Tit Progger 1.8.1..configure it for correct port under "settings"
Press the green symbol to connect - it will either say unrecognised OS or OS 1.2, If it says
unrecognised OS look under tools at the top and select erase c*rd. If it says OS 1.xx then it
will start to upgrade the OS to 1.5, when this is complete press the red symbol to disconnect.
Now start Titanium Progger 1.9.0 and you will see either unrecognised OS or OS 1.5, If it says
unrecognised OS look under tools at the top and select erase c*rd. If it says OS 1.xx then it
will start to upgrade the OS to 1.6.
With some programmers nothing happens until you press ctrl+alt+del to bring up task manager, and
for whatever reason that will kick start the programmer.
Your c*rd is prepared now to program the eep and the hex file, when you unzip the file there will
be either 2 or 3 files in it, unzip them to the same directory as your Titanium Progger, and load
them It is obvious which file goes where.
Hit the Burn Button....and wait until it finishes, click on red symbol, and you will have a
working Titanium c*rd.
Next time you program your c*rd you will need to click tools---->erase, you need a c*rd in its virgin state to program the files into.